2021 Ford Super Duty F-600 DRW Chassis XL 2WD Reg Cab 145" WB 60" CA

Total

$57,009.00

Related Trims:
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$100.00
$0.00
(STD)
$10,075.00
transmission mounted live drive and stationary mode PTO, 27 litre (7.2 gallon) plastic urea tank, exhaust brake, B20 capability, urea gauge and intelligent oil life monitor, 397 Amp Alternators, Rapid-Heat Supplemental Cab Heater, Dual 78-AH 750 CCA Batteries
Read more
$0.00
10R140 w/neutral idle, SelectShift and selectable drive modes: normal, tow/haul, eco, deep sand/snow and slippery
$0.00
Spare may not be the same as the road tire
$320.00
Spare may not be the same as the road tire
$300.00
Spare may not be the same as the road tire, 4 traction tires on the rear and 2 A/P tires on the front
$0.00
integrated armrest w/2 cupholders and driver manual lumbar
$260.00
integrated armrest w/2 cupholders and driver manual lumbar
$390.00
driver manual lumbar
$650.00
driver manual lumbar

Selecting an option here is not required

$220.00
Chrome Front Bumper
$500.00
XL Decor Package, Chrome Front Bumper, Cruise Control
$0.00
$300.00
$400.00
hardened engine intake valves and valve seats, Note: This package does not include CNG/propane fuel tanks, lines, etc, Vehicle will be equipped w/the standard factory gasoline fuel system, Additional equipment combined w/certified calibration reflash is required, from an external upfitter, to convert the vehicle to a CNG/propane fueled vehicle, Ford Motor Company does not provide an exhaust or evaporative emissions certificate w/this option when converted to use CNG or propane fuel, Ford does not represent that a vehicle converted to use CNG or propane will comply w/all applicable U.S, or Canadian safety standards, It is the responsibility of the final stage manufacturer (body builder, installer, alterer or subsequent stage manufacturer) to determine that any vehicle converted to use CNG or propane complies w/U.S, federal, California, or Canadian exhaust and evaporative emission requirements, Federal fuel economy standards, U.S, and Canadian safety standards,
Read more
$200.00
$200.00
$200.00
$350.00
smart trailer tow connector, Verified to be compatible w/electronic actuated drum brakes only
$160.00
pre-selected springs (see Super Duty Supplemental Reference Manual for springs/GAWR of specific vehicle configurations), Note 1: Restrictions apply; see Super Duty Supplemental Reference Manual or Body Builders Layout Book for details, Note 2: Also allows for the attachment of a winch, Note 3: Upgraded front springs will result in stiffer ride when a snow plow is not installed
Read more
$100.00
2-inch spacer blocks, Recommended for rear-biased loading, such as wrecker/retriever applications
$-75.00
$890.00
Combines 151 litre aft-of-axle tank, 100 litre mid-ship tank and dual fuel fill on driver's side
$410.00
Excludes carrier, 6-Ton Hydraulic Jack
$150.00
$490.00
$0.00
Standard in British Columbia, Manitoba, New Brunswick, Ontario and Saskatchewan
$220.00
$800.00
Custom accessory, 2 lights mounted on the centre high-mounted stop light bar and 2 hood mounted lights
$800.00
Custom accessory, pre-installed, alternating amber/white flash pattern
$40.00
$225.00
$350.00
$290.00
$290.00
$400.00
Automatic Emergency Braking (AEB), automatic high beams and forward collision warning
$150.00
$550.00
loose camera and wiring bundle
$400.00
the UIM pre-installed and interface cables (2- 3' blunt cut cables w/connectors), Note: The Upfitter Interface Module (UIM) is an electronic control module that provides output signals for aftermarket equipment (such as lift buckets, cranes, motors, salt spreaders, snow plows, etc.) via customer programmable logic based on switch inputs and vehicle CAN bus messages, The operation of such equipment is limited to the load parameters of the UIM, The UIM does not come pre-programmed for use, It must be configured by the upfitter for aftermarket equipment, The UIM provides output signals only, and is not intended to directly power any aftermarket device, Customer must use external relays to drive any equipment, Ford Motor Company is not responsible for debugging or verifying the function of the customer created UIM program files, It is the responsibility of the upfitter to ensure proper function of the software created to complete their upfit
Read more
$250.00